Pay Attention To The Problem That The Waveform Of The ECG Monitor Does Not Display

Apr 15, 2021

Leave a message

a. Wipe the 5 specific positions of the human body with the sand pads on the electrode pads, and then use 75% ethanol to clean the surface of the measuring parts to remove the stratum corneum and perspiration on the human skin and prevent poor contact of the electrode pads.

b. Fasten the electrode tip of the ECG lead wire with the electrodes on the 5 electrode pads.

c. After the ethanol evaporates, attach the 5 electrode pads to the cleaned specific positions to make the contact reliable and prevent them from falling off.

And do a good job of related education for patients and their families: instruct patients and other personnel not to pull the electrode wires and lead wires, and inform patients and relatives not to use or adjust the monitor without authorization, which may cause damage to the instrument. Some patients and their family members have a sense of mystery and dependence on the monitor, and the oscillometric changes of the monitor can cause anxiety and panic. Nursing staff should provide adequate and necessary explanations to avoid interfering with normal nursing work and affecting the nurse-patient relationship.

Pay attention again to the maintenance when using the monitor for a long time: the electrode is easy to fall off after long-term application, which affects the accuracy and monitoring quality. Replace it every 3-4d; at the same time, check and pay attention to the cleanness and disinfection of the skin, especially in the hot summer.

Professional re-examination and maintenance: When a serious abnormality of the instrument is found during the monitoring process, it is best to ask professional electrocardiogram room personnel for re-examination and diagnosis, and the manufacturer's maintenance personnel professionally repair it.

Connect the ground wire method when connecting: Connect the end with the copper sheet sleeve to the ground terminal on the rear panel of the host when the ground wire is used. (The method is to unscrew the ground terminal knob cap, put the copper sheet on, and then tighten the button cap). There is a clamp on the other end of the ground wire. Please clamp it to the public grounding end of the building facility (the water pipe, the radiator, etc., where it is directly connected to the ground).


Send Inquiry
Send Inquiry